PC-Universal Glue™ is a new high-performance adhesive that has unlimited uses. The non-foaming formula provides ultimate strength (1700psi). The glue is a white color but dries clear. This product may be diluted with water.

Once the product is fully cured, the bond will be resistant to gasoline, oils, grease, salt water, mild detergents and acids and mold and mildew. Comprised of a 100% non-toxic formulation. No VOC’s, Isocyanides or formaldehyde.

Directions: Apply glue to both sides of surfaces to be bonded and let stand for 1-2 minutes before bonding together. For heavy duty bonding, use as in container. No mixing required. Prior to using, make sure all surfaces and clean and free on debris, oil, rust etc. Glue may be diluted up to 25% for further coverage and economy. For use as a sealer, the glue may be diluted up to a 5:1 Ratio by mixing 1 part of PC-UNIVERSAL GLUE with 5 parts of water. After diluting, the glue may be spread on the bonding surfaces. Allow to dry for 1 hour. Apply undiluted glue to surface and tape or clamp in place until fully cured. Use at temperatures above 50°F (10°C) and 200°F (92°C).

Glue will not bond to: Cast Metals, polyethylene, Teflon®, un-backed vinyl, P.V.C., and polypropylene. Test area if in doubt. Cures in 24 hours. DO NOT ALLOW TO FREEZE. 1700 psi. bond strength. PC-Universal Glue can be applied with a roller, brush or directly from the container. PC-Universal glue may be diluted for bonding where maximum strength is not needed. For sealing porous masonry or drywall, the solution may be up to 5 parts water to 1 part glue. For best results, apply glue at temperatures above 50°F and do not expose to temperatures above 200°F.